Technical Data & Specification Properties

Technical Data

Technical Data & Testing Results
Test Description
Initial (After 14 days room temperature cure) Percent elongation 70˚ F – 350%
32˚ F – 275%
Tensile Strength 70˚ F – 275%
32˚ F – 325%
Flexibility to pouding water (GMS – 24 hrs.) 0.3 GMS
Resistance Film At – 15˚ F wraps around one-half inch mandrel.
Resistance to wind driven rain (TT-P-555B) 0.05 pounds
Moisture vapor permeability 0.5 perms
Shore A hardness 29 to 30
Aluminum Shrinkage No pulling or cracking away from rim.
Pressure clean up to 2500 psi using a fan nozzle 45°
Accelerated weathering 1500 hrs. QUV No effect on shades or film integrity
Chemical resistance-3 drops of chemical placed on panels for 24 hrs. Mineral Sprits-No effect.
Muriatic Acid-Slight softening and staining. Recovers after rinsing.
Salt Spray resistance (ASTM B-117-64) Ammonia- No effect.
500 hrs. – No yellowing or other adverse effects.


Tensile strength and percent elongation
after QUV Exposure 250 hours
Percent elongation
Tensile Strength
500 hrs.
70˚ F – 320%
70˚ F – 315 PSI
Percent elongation 70˚ F – 280%
Tensile Strength 70˚ F – 340 PSI
Exterior Stucco Finish

PRODUCT DESCRIPTION
Exterior Stucco Finish is a heavy bodied texture finish that can be applied by troweling, spraying or sponging.

GENERIC TYPE:
Styrene Acrylic.

RECOMMENDED USES:
For use on concrete, concrete blocks, cement plaster, pre-cast and poured concrete, drywall and cement board.

SPECIAL FEATURES

  • Highly resistant to water or moisture penetration.
  • Provides weather resistant finish to walls.
  • This product is a high build type coating that can be applied up to 60 mils thickness.
  • Has an excellent recovery property which allows expansion and contraction over a wide range of temperatures without affecting its original state.
  • Excellent efflorescence resistance.
  • Colour fast in light tints and pastels.
  • Breathes.

SURFACE PREPARATIONS:
Surfaces to which Exterior Stucco Finish is to be applied should be dry and free from grease, loose sand, efflorescence, peeling paint or any materials that may affect adhesion.

STORAGE:
Keep container tightly sealed. DO NOT STORE IN DIRECT SUNLIGHT.

CURING TIME:
Initial set approximately 30 minutes. Hard dry in 90 minutes. Full cure 7 days.

CLEAN UP:
Product is water based. Wash tools using water before product sets.

LIMITATION:
Do not apply to surfaces below 50˚ F.

SPREAD RATE:
12 m² per 19 litres on properly prepared surfaces.

OPENT TIME:
Approximately 60 minutes depending on weather conditions.


Hit Counter provided by laptop reviews